West Mountain Radio RIGblaster DXpro, Руководство по эксплуатации, Страница: 15 / 26

15
West Mountain Radio Operating Manual
The DXpro Settings program requires exclusive use of the DXpro Control Port.
If this is currently in use by your digital mode software you will need to exit your
software before double clicking on the DXpro Control Port.
Description of Settings
Push To Talk Logic:
VOX/RTS
: This setting has four options: Per Switch, Force Off, Force VOX, and
Force RTS. It will override the front panel PTT switch even when set to the TX
inhibit position, and would normally only be used when operating remotely. Per
Switch is the default.
Sequencer : This setting enables the sequencer ports. The logic may be
changed to high or low depending on the requirements of your sequencer. If
needed you may test this function without a sequencer by using a loopback
cable between the SEQ TRIG and SEQ END ports on the rear panel.
Right Channel Tone :
This option is for programs such as FLdigi (which can output a pseudo-FSK
signal on the sound card right channel) and for CW software which does not
have a serial keyed output.
There are three options: Off, CW, and RTTY. For normal digital mode operation
(e.g. FT-8, PSK31, etc) this must be set to Off. When set to RTTY ensure the
DXpro Main/Sub/TX sound card playback volume level is at least 75% or the
unit may fail to produce FSK.
Time
If required, you can add a delay in mS before the DXpro will transmit. Default
value is 0mS.
VOX
This control when enabled will override the VOX Delay control knob on the front
panel of the DXpro. This option would normally only be used remotely if needed.
Voice Keying
Mode:
There are three options Off, Foot tap, and Analog Keypad.
When set to Off, the footswitch jack behaves like a normal footswitch
input i.e. hold down to transmit.
When set to Foot tap, in addition to hold/transmit; single, double,
and triple taps will toggle serial input signals. This is used for
voice keying software to select which message to play.