West Mountain Radio RIGblaster DXpro, Руководство по эксплуатации, Страница: 11 / 26

11
West Mountain Radio Operating Manual
a fixed-level audio cable to drive LINE IN leave it disconnected.
LINE IN : Receive audio from your transceiver should be connected here. You
can use the supplied stereo audio cable to hook up from the transceiver’s
external speaker connection or an optional fixed-level audio cable from an
accessory jack. The jack is 3 pole so use of a stereo cable is recommended
even with a transceiver with a mono output jack. This prevents the ring being
grounded.
SQ : Optionally connect your transceiver’s SQUELCH output here.
FOOT SW : This port may be used for a traditional foot switch or a 4 key keypad.
SEQ TRIG : This port provides a trigger signal to an attached sequencer.
Transmit is inhibited on the DXpro until a signal is detected on the SEQ END
port.
SEQ END : This port expects the time-completed signal from the sequencer.
MIC : This jack will be used either for an RJ-45 type microphone or connection to
your transceiver’s 8-pin metal round microphone jack depending on which type
of transceiver is being used.
Verifying The DXpro Installation
The DXpro, when connected to the computer, will provide two virtual COM ports
and two sound cards. Open up Windows Device Manager to verify you can see
the COM ports and the audio devices.
If you followed the earlier instruction to install the West Mountain Radio Device
Diagnostic software you will have a notification area icon (red antenna) like this: