Wessex Lift Company Limited
Darren Windibank
Phone: 0044(0) 1794 830303
Fax: 0044(0) 1794 512621
Email: [email protected]
Page
4
of
4
Adding a handset
To add a handset to an existing system:
Figure 6: Receiver
1.
Hold a magnet over the area indicated in
Figure 6. You may need to move the magnet
around slightly.
2.
You will hear a short bleep. The bleep
indicates the start of a ten second period in
which a handset can be added.
3.
Press and release the Up arrow button on the
handset to be added. Ensure the Green LED
on the handset illuminates.
4.
At the end of the ten second period you will
hear two long bleeps. This indicates the
system has returned to its normal operating
condition.
5.
Test all handset buttons function correctly.
Test Procedure
1.
Test the Up direction button on all handsets. Ensure the Green LED on the handset illuminates.
2.
Test the Down direction button on all handsets. Ensure the Green LED illuminates.
3.
Test the Stop button on all handsets. Ensure the Green LED illuminates.
4.
Test the Door button on all handsets. Ensure the Green LED illuminates.
•
For power doors, the door should open and close.
•
For manual doors, the lock should release.
Checks in the event of a problem
1.
If the Red LED on the handset flashes after a button is pressed, this indicates a low battery. Replace
the AAA batteries.
2.
Check the Green LED on the handset illuminates when a button is pressed. If the Green LED fails to
light, check the AAA batteries.
3.
Check the dip switches are correctly set (refer to drawing VM30 8105).
4.
Check the Wireless Call Station Looms are correctly wired and connected. The link wire connects from
pin 1 to pin 4 (see Fig. 4).
5.
Check the receiver loom wiring to PLK is correct (refer to drawing VM30 8105).
6.
With all connections made, check there is 24V DC on the Red wire (pin 8) on the receiver loom at PLK.
7.
If all the above checks are sound,
check all wiring to the receiver PCB
(refer to drawing VM30 8105).
Remove the receiver, unscrew and
remove the antenna, remove the two
screws at the base of the receiver
casing and slide out the receiver PCB.
When reassembling, note that the PCB
locates into slots moulded into the
receiver casing.
Figure 7: Receiver PCB
