background image

13

9.

Make sure that all parts are properly tightened before you use the treadmill.

Note: Extra hardware may

be included. Keep the included hex keys in a secure place. The large hex key is used to adjust the walking
belt (see page 17). To protect the floor or carpet, place a mat under the treadmill. 

5

67

84

65

40

8. Press the Wire Harness (65) into the recessed track on

the back of the Console Base (67). Note: There may be a
cylinder on the Wire Harness preventing it from being in-
serted into the track. Press as much Wire as possible into
the track.

Insert the excess Wire Harness (65) into the large hole in
the side of the Right Handrail (40). 

Securely tighten the

nylon tie to prevent the Wire Harness from slipping.

Then, cut off the end of the nylon tie.

Attach the Access Door (84) to the Console Base (67) with
the 1/2” Screw (5).

Tighten, but do not overtighten, the bolts used in step
5. With the help of a second person, lower the up-
rights and firmly tighten the bolts used in steps 2.

8

Tie

Track

Tie

7. Place the Console Base (67) on the Right Handrail (40)

and the Left Handrail (not shown). 

Insert the Wire Harness (65) through the indicated nylon tie
on the Console Base (67). Next, 

touch the Right Handrail

(40) to discharge any static. 

See drawing 7a. Find the

connector on the end of the Wire Harness. Insert the con-
nector into the red socket beneath the Console (69). 

The

connector should slide easily into the socket and snap
into place.

If the connector does not slide easily and snap

into place, turn the connector and then insert it. 

IF THE

CONNECTOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.

Identify the 3/4” Screws (38); 

be careful not to confuse

the 3/4” Screws with the 1/2” Screw (5). 

Attach the

Console Base (67) to the Right Handrail (40) and the Left
Handrail (not shown) with eight 3/4” Screws (only four
Screws are shown). 

Start all eight Screws before tight-

ening them. Do not overtighten the Screws.

Tighten the Crossbar Screws (37).

65

67

38

38

7a

65

69

7

40

6. Attach the end of the ground wire to the small hole in the

side of the Right Handrail (40) with a Silver Ground
Screw (66).

Open part bag C. 

Attach the Crossbar (39) to the Right

Handrail (40) and the Left Handrail (131) with two
Crossbar Screws (37).

Do not tighten the Crossbar

Screws yet.

Make sure that the rectangular hole in the

Crossbar is on the indicated side.

Ground Wire

Hole

6

66

39

40

37

37

131

8

HOW TO USE A PRESET PROGRAM

Insert the key into the console.

See HOW TO TURN ON THE POWER on page
11.

Select one of the preset programs.

When the key is in-
serted, the manual
mode will be selected.
To select a preset pro-
gram, press the
Program button repeat-
edly until one of the five
program indicators lights. Note: The graphs be-
side the program indicators show how the speed
and incline of the treadmill will change during the
programs.   

Each program consists
of either 20 or 30 one-
minute periods. One
speed setting and one
incline setting are pro-
grammed for each pe-
riod. The speed setting
for the first period appears in the left column of the
matrix. The speed settings for the next five
periods appear in the five columns to the right.
Note: One bar in a column represents a speed
setting of either 1 mph or 1.5 mph; two bars repre-
sent a speed setting of 2 mph or 2.5 mph; three
bars represent a speed setting of 3 mph or 3.5
mph; and so forth. 

Even if the same number of

bars appear in two consecutive columns, a
different speed setting may be programmed
for each period.

Press the Start button or the Speed increase
button to start the program.

When the button is pressed, the left column of the
matrix will begin to flash, and the treadmill will au-
tomatically adjust to the speed and incline settings
for the first period. Hold the handrails and begin
walking. 

When the first period of the program ends, a se-
ries of tones will sound and 

all speed settings will

move one column to the left.

If the speed and/or

incline of the treadmill is about to change, the
Speed display and/or the Incline display will
flash to alert you.

The speed setting for the sec-

ond period will then appear in the left column of the
matrix and the treadmill will automatically adjust to
the speed and incline settings for the second pe-
riod. 

The program will continue until the speed setting
for the last period appears in the left column of the
matrix and the last period ends. The walking belt
will then slow to a stop.

If the speed or incline setting is too high or too low
at any time during the program, you can manually
override the setting by pressing the Speed or
Incline buttons. However, 

when the next period

begins, the treadmill will automatically adjust
to the speed and incline settings for the next
period.

To stop the program, press the Stop button. The
Time/Pace display will begin to flash. To restart
the program, press the Start button or the Speed
increase button. The walking belt will begin to
move at 1 mph. When the next period begins, the
treadmill will automatically adjust to the speed and
incline settings for the next period.

Follow your progress with the displays.

See step 5 on page 11.

Measure your heart rate if desired.

See step 6 on page 12.

When you are finished exercising, remove the
key.

When the program ends, 

make sure that the

treadmill is at the lowest incline level.

Next, re-

move the key from the console and put it in a 
secure place.

When you are finished using the treadmill, move
the on/off switch to the off position.

6

5

4

3

2

1

Program Indicator

Current Period

37

Содержание WETL28131













Отзывы: