6
5
5. The Console (5) requires two 1,5V AA batteries; alka-
line batteries are recommended. Remove the battery
cover from the Console. Insert two batteries into the
Console.
Make sure that the batteries are oriented
as shown by the diagram inside the Console.
Then,
reattach the battery cover.
Batteries
Battery
Cover
5
4
51
59
59
44
31
30
44
40
13
51
1
2
59
51
4. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (30) to
the Reed Switch Wire (31). Next, connect the
Resistance Cable (13) to the Lower Cable (40) in the
following way:
• See the inset drawing. Insert the end of the
Resistance Cable (13) through the connector from
the side shown. Next, press the small cylinder on the
end of the Resistance Cable into the indicated hole
in the connector.
• Pull the Resistance Cable (13) upward and insert it
into the hole in the top of the connector.
Carefully pull the excess Upper Wire Harness (30)
upward from the top of the Upright (2), push the
excess Cables (13, 40) down into the Frame (1), and
slide the Upright onto the Frame.
Be careful to avoid
pinching the Wires and Cables.
Next, attach the
Upright with four M8 x 20mm Button Screws (51), four
M8 Spring Washers (59), and four M8 Curved
Washers (44).
Be careful to
avoid pinching
the wires and
cables.
40
30
13
31
