13
Turn on the console.
See step 1 on page 12.
Select one of the preset programs.
Each time the
console is turned
on, the manual
mode will be
selected. To
select a preset
program, press
the Program
Select button repeatedly until the number 1, 2, 3,
4, 5, 6, 7, or 8 appears in the upper right corner
of the display.
The profiles numbered 1 through 8 on the right
side of the console show the resistance and pace
settings for the preset programs. For example,
profile number 3 shows that when preset program
3 is selected, both the resistance level and the
pace will gradually increase during the first half of
the program and then gradually decrease.
Start the program.
To start the program, simply begin pedaling. Each
preset program consists of either 20 or 30 one-
minute periods. One resistance setting and one
pace setting are programmed for each period.
(The same resistance setting and/or pace setting
may be programmed for two or more consecutive
periods.)
During the program, the resistance of the elliptical
exerciser will automatically change as shown by
the applicable profile on the console. Note: If the
current resistance level is too high or too low, you
can change the resistance level by pressing the +
or – button. However, when the current period of
the program is completed, the resistance level will
automatically change if a different resistance set-
ting is programmed for the next period.
The target pace
settings for the
program will be
shown by the
right pace indica-
tor in the display.
(The left indicator
will show your
actual pedaling pace.) As the right indicator
changes in height during the program, adjust your
pace so that both indicators are at the same
height. If your pace is slower than the current tar-
get pace, the increase arrow will appear in the
display to prompt you to increase your pace; if
your pace is faster than the target pace, the
decrease arrow will appear.
Important: The pace
settings for the program are intended only to
provide a goal. Your actual pace may be slow-
er than the pace settings, especially during
the first few months of your exercise program.
Make sure to pedal at a pace that is comfort-
able for you.
During the program, the display will show the time
remaining in the program. When no time remains,
the program will be completed. If you continue
pedaling after the program is completed, the dis-
play will continue to show your exercise feedback.
Follow your progress with the feedback modes.
See step 4 on page 12.
Measure your heart rate if desired.
See step 5 on page 12.
When you are finished exercising, the console
will automatically turn off.
See step 6 on page 12.
6
5
4
3
2
1
HOW TO USE A PRESET PROGRAM
Increase Arrow
