6
50
8
27
7. Identify the Left Handlebar (6), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Arms (5);
make sure that the Handlebar
Arm is turned so the hexagonal holes are on the
indicated side
. Attach the Left Handlebar to the
Handlebar Arm with two M6 x 38mm Button Bolts (50)
and two M6 Nylon Locknuts (27).
Make sure that the
Nylon Locknuts are inside of the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Apply a small amount of the included grease to the left
axle on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Slide a
Handlebar Spacer (47) and the Left Handlebar onto the
left axle on the Upright (2) as shown.
Make sure that the
Handlebar Spacer is turned so the curved side is fac-
ing the Upright.
Tap an Axle Cap (14) onto the axle.
Repeat this step to assemble the Right Handlebar (8)
and the other Handlebar Arm (5).
Grease
7
47
14
49
5
2
5
6
8
36
11
13
8. Identify the Left Pedal Arm (11). Attach a Pedal (13) to
the Left Pedal Arm with two M6 x 48mm Flat Head
Screws (36).
Attach the other Pedal to the Right Pedal Arm (not
shown) in the same way.
Hexagonal
Holes
6
1
2
33
Make sure that
the wires and
cables do not
get pinched
and damaged
during this
step.
44
53
48
55
63
59
6. Whilst another person holds the Upright (2) near the
Frame (1), connect the Speed Wire (44) to the Reed
Switch Wire (53). Next, connect the Resistance Cable
(63) to the Lower Cable (55) in the following way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (55), and insert the tip of the
Resistance Cable (63) into the wire clip inside of the
metal bracket.
• See drawing B.
Firmly
pull the Resistance Cable
(63) and slide it into the metal bracket on the Lower
Cable (55) as shown.
• See drawing C. Using pliers, squeeze together the
prongs on the upper end of the metal bracket.
Push the excess cable and wire down into the Frame
(1). Slide the Upright (2) onto the Frame.
Be careful
not to pinch the wires or cables.
Attach the Upright
with two M10 x 68mm Button Bolts (48), two M10 Split
Washers (59), and two M10 Nylon Locknuts (33).
Do
not tighten the Button Bolts yet.
55
55
Metal
Bracket
B
A
C
55
63
63
63
