4
ASSEMBLY
Assembly requires two persons.
Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the
included hex keys and your own Phillips screwdriver
, adjustable wrench
,
and rubber mallet
.
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is
the quantity needed for assembly.
Note: Some small parts may have been pre-assembled. If a part is not in
the parts bag, check to see if it has been pre-assembled.
M6 x 38mm Button
Bolt (50)–4
M4 x 16mm
Screw (42)–4
M10
Washer (35)–2
M10 Split
Washer (59)–2
M10 Nylon
Locknut (33)–6
Pedal Arm Bolt Set (40)–2
M10 x 25mm Patch Screw (22)–2
M10 x 75mm Carriage
Bolt (34)–4
M10 x 68mm Button
Bolt (48)–2
M6 x 48mm Flat Head
Screw (36)–4
M8 x 16mm Button
Screw (68)–2
M8 Split
Washer (69)–2
M6 Nylon
Locknut (27)–4
Wave Washer
(70)–2
1. Identify the Front Stabiliser (10), which is narrower than
the Rear Stabiliser (not shown). Whilst another person
lifts the front of the Frame (1), attach the Front
Stabiliser to the Frame with two M10 x 75mm Carriage
Bolts (34) and two M10 Nylon Locknuts (33).
10
33
34
1
1
