Weslo Gym 1500, Руководство пользователя

Страница: 7 / 27

7
4. Attach the two Base Supports (22) to the
Stabiliser (2) with two M10 x 70mm Bolts (64),
two M10 Washers (62), and two M10 Nylon
Locknuts (68).
Attach the Base Supports (22) to the Base (1)
with an M10 x 73mm Bolt (80) and an M10 Nylon
Locknut (68).
Do not tighten the M10 Nylon Locknuts (68) yet.
5. Press two 50mm Square Inner Caps (51) into the
ends of the Top Frame (4). Press two 45mm
Square Inner Cap (52) into the crossbar on the
Top Frame.
Attach the Top Frame (4) to the Upright (3) with
the Support Plate (86), two M10 x 70mm Bolts
(64), and two M10 Nylon Locknuts (68).
Attach the Top Frame (4) between the Weight
Guides (16) with an M10 x 155mm Bolt (76), two
M10 Washers (62), two 19mm Spacers (29), and
an M10 Nylon Locknut (68).
Tighten the M10 Nylon Locknuts (68) used in
steps 1–5.
6
4
5
2
1
51
51
52
52
4
29
86
64
29
76
62
62
68
68
16
62
68
68
68
64
22
22
80
64
3
50
49
9
10
49
Lubricate
Axles
Axles
Bracket
Bracket
73
50
49
73
52
52
4
55
55
Arm Assembly
6. Lubricate both axles on the Top Frame (4) with
grease. Identify the Right Butterfly Arm (10) by the
position of the bracket. Press a 27mm x 63mm
Plastic Bushing (55) into the Right Butterfly Arm,
and slide the Arm onto the right axle on the Top
Frame.
Be sure that the upper end of the
Butterfly Arm is behind the indicated bracket
on the Top Frame.
Tap two 25mm Retainers (50) and a 25mm Cover
Cap (49) onto the right axle.
Be sure that the
teeth on the Retainers bend toward the Cover
Cap, as shown in the inset drawing.
Attach the Left Butterfly Arm (9) in the same
manner.
Press two 45mm Square Inner Caps (52) into the
lower ends of the Butterfly Arms (9, 10). Wet the
end of each Arm with soapy water, and slide two
Large Foam Pads (73) onto the Arms.