Weslo Daybreak 510, Руководство пользователя

Страница: 10 / 24

10
4. Wipe out the spa shell using a damp cloth. Remove
the two warning decals (not shown) from the spa
shell. Before you fill the spa, be sure that it is in the
position you want, and that it can be easily ser-
viced, if needed. Once the spa is filled with water, it
must be drained to be moved.
See the inset drawing. Locate the weir door and
pull it toward you until it is fully open. Insert a gar-
den hose or other clean water source into the filter
housing, and fill the spa. The spa can be filled with
cold water; however, if you use warm or hot water,
it will be ready to use sooner. Fill the spa until the
water is about four inches below the console. Do
not overfill the spa.
5. Place the Spa Cover (18) over the spa. Be sure
that the Spa Cover is properly centered.
Snap a Buckle (2) onto each of the four latches on
the Spa Cover (18).
See the inset drawing. Position one of the Buckles
(2) on the wood panels on the Spa Unit (15) and
hold the Buckle in place, so the strap on the Spa
Cover (18) is tight. (Note: It may be easier to posi-
tion the Buckles if a second person holds the strap
on the opposite side of the Spa Cover tight.) The
Spa Cover must be tight. Do not place the
Buckle over one of the grooves in the wood
panels. Remove the latch. Attach the Buckle to the
side of the spa with two Buckle Screws (1). Note: It
may be helpful to use a drill with a 1/16” drill bit
to make starter holes in the wood panels. You
may also want to apply a little soap or wax to
the screw threads.
Attach the other three Buckles (2) to the Spa Unit
(15) in the same manner.
Fill to Here
4
5
18
15
2
2
1
Strap
Latch
Weir Door