6
3. Attach the Console Base (12) to the Handrails (30, 32)
with four Screws (48).
Feed the excess Wire Harness (28) into the upper end of
the Right Handrail (32).
Tighten all parts used in steps 2 and 3.
4. Attach the Storage Catch (80) and the Catch Spacer
(44) to the left side of the Frame (76) with four Screws
(48). Be careful not to overtighten the Screws.
Make
sure that the Storage Catch and the Catch Spacer
are turned as shown.
5. Remove the backing from the Wrench Clip (91). Press
the Wrench Clip onto the base of the right Upright (31) in
the indicated location. Press the Allen Wrench (90) into
the Wrench Clip.
Feed the excess Wire Harness (28) into the right Upright
(31).
6. The console requires two "AA" batteries (not included).
Alkaline batteries are recommended. To install batter-
ies, open the battery cover as shown at the right. Press
the batteries into the battery compartment, with the neg-
ative (Ð) ends of the batteries touching the springs.
Close the battery cover, push up on the tab, and then
push the tab forward as shown in the inset drawing. Be
sure that the tab locks into place.
7.
Make sure that all parts are tightened before you use
the treadmill.
Note: The ratchet screws are factory set
and
should not be adjusted.
To protect the floor or carpet, place a mat under the
treadmill.
30
48
48
32
28
3
12
44
80
76
48
90
91
31
28
5
Ratchet
Screws
7
4
Batteries
Battery Cover
Battery
Cover Tab
6
