7
3. Raise the Uprights (6, 17) to the vertical position. Place
the Frame (55) between the Uprights as shown.
Feed the Wire Harness (22) into the large round hole in
the lower end of the Right Upright (6) and out of the indi-
cated hole. Note: It may be helpful to use needlenose pli-
ers to pull the end of the Wire Harness out of the hole.
22
22
6
17
55
3
4. Hold the Right Frame Spacer (16) and the Left Frame
Spacer (not shown) against the sides of the Frame (55) as
shown.
Make sure that the widest side of each Frame
Spacer is facing forward.
With the help of a second per-
son, carefully lift and hold the Frame so the Frame
Spacers are between the Right Upright (6) and the Left
Upright (not shown).
Align the hole in the Right Upright (6) with the hole in the
Right Frame Spacer (16). Tighten a 6 1/2” Bolt (10) with a
3/8” Star Washer (42) into the Right Upright, the Right
Frame Spacer, and the Frame (55).
Repeat this step on
the left side of the treadmill. Do not overtighten the
Bolts.
42
10
16
Wide
side
6
55
63
64
64
6
17
19
Large
Hole
Small
Holes
Small
Holes
19
15
15
28
30
30
6, 17
Hole
2
2a
2b
6, 17
2. Identify the Right Upright (6), which has a large round
hole near the lower end, and the Left Upright (17).
See drawing 2a. Make sure that there are two U-nuts
(63) in the lower end of each Upright (6, 17).
Open part bag B.
See drawing 2b. Have a second per-
son hold the Base (28) so it is resting on the Wheels (15)
as shown. Attach the Right and Left Uprights (6, 17) to
the Base with four 3” Bolts (30) and four 5/16” Star
Washers (64).
Do not tighten the Bolts yet. Make sure
that the large and small holes in the Right Upright
are on the sides shown, and that the small holes in
the Left Upright are on the indicated side. In addition,
make sure that the Base is oriented so the Base Pads
(19) are in the location shown.
4
