8
7.
Make sure that all parts are tightened before you use
the treadmill.
Note: The ratchet screws on the adjustable
rear incline are factory set and
should not be adjusted.
Keep the included allen wrench in a secure place. The
allen wrench is used to adjust the walking belt (see page
20). To protect the floor or carpet from damage, place a
mat under the treadmill.
4. Remove the Lock Knob (54) from the Lock Pin (59).
Press the Lock Knob Sleeve (55) into the left Upright (61).
Make sure that the Lock Pin Collar (57) and the Spring
(56) are on the Lock Pin. Insert the Lock Pin into the left
Upright (61) and tighten the Lock Knob onto the Lock Pin.
59
61
56
57
55
54
4
5.
Note the location of the 75 ohm antenna terminal on
the treadmill (for clarity, the treadmill is shown in the
storage position). For the television to operate prop-
erly, an antenna, a CATV cable, or a VCR must be con-
nected to the 75 ohm antenna terminal.
If you are using an antenna,
it must be properly con-
nected and adjusted for optimal reception. Refer to AN-
TENNA CONNECTIONS on pages 12 and 13 to properly
connect an antenna.
If you are using a CATV cable,
refer to CATV CABLE
CONNECTION on page 13 to properly connect the cable.
If you are using a VCR,
refer to HOW TO CONNECT A
VCR on page 17 to properly connect the VCR.
The VCR
must be turned on, a videocassette must be properly
inserted, and the VCR must be playing. Refer to your
VCR userÕs manual for operating instructions.
6. The console requires
two "AA" batteries
(not included).
Alkaline batteries are recommended. To install batteries,
first open the Battery Cover (98) as shown. Press two
batteries into the battery compartment, with the negative
ends of the batteries (marked ÒÐÓ) touching the springs.
Close the battery cover, push up on the battery cover tab,
and then push the tab forward as shown. Be sure that the
tab locks into place.
5
6
Ratchet
Screws
Batteries
98
75 Ohm
Antenna
Terminal
Battery
Cover Tab
7
