Page
5
of
26
©Copyright 2018 WESCO Industrial Products, LLC. Specifications subject to change. Not responsible for errors or omissions.
Electric Non-Telescoping High Lift Truck
(Part # 272460 & 272461)
Instruction Manual
ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR HIGH LIFT TRUCK,
READ THESE INSTRUCTIONS ENTIRELY BEFORE USING.
6. BATTERY CHARGING AND REPLACEMENT
• Only qualified personnel are allowed to service or charge the batteries. The instructions of this
manual and from the battery manufacturer must be observed.
• 12V/52Ah
• These batteries are maintenance free; re-filling is prohibited.
• Park the truck securely before starting charging or installing/changing the batteries
• Before finishing maintenance work, make sure, that all cables are connected correctly.
6.1 Replacement
FOR REPLACEMENT YOU NEED TO LIFT THE TRUCK. BLOCK THE SCISSOR MECHANISM
TO PREVENT LOWERING!
Park the truck securely, switch off the truck with the key switch and remove the emergency plug.
Loosen the upper cover with the 2 screws. Also remove the backside fixing bar (also with 2 screws).
Disconnect the terminals (Fig. 4) and take the
battery out.
The installation is in the reverse order of the
removal. Please connect the positive terminals
firstly; otherwise the truck could be damaged.
6.2 Battery indicator
Discharge status is indicated by ten red LED segments.
Battery Discharged
Battery Fully Charged
Fig.5: Battery Discharge Indicator
• When the battery is properly charged, all the LED illuminate. During discharge successively less
LEDs lights up.
• When the last 3 LEDs are lit, the battery is fully discharged. The battery must be charged before
further operation, otherwise the lifetime of the battery will be reduced and/or the battery could be
damaged!
Fig.4: Battery Replacement
