- -
- 8 -
5.0 INSTALLATION
5.1 FLANGE ASSEMBLY
Before mounting the flange, clean the conical surface of the spindle (1 Fig. 4) and the surface of
the flange (2 Fig. 4). Place the flange on the spindle so the position of the markers (3 Fig. 4) on the
spindle's snug and on the flange are aligned as shown in Fig. 4. Lastly, screw the holder onto the
spindle with the bolt (4 Fig. 4).
WARNING:
A thorough cleaning of the conical surfaces of the spindle and the flange, together with the
maintenance of the positions indicated by the red markers, have to be considered basic
conditions for a correct operation of the wheel balancer. The flange described must be used for
the balancing of car wheels.
Fig. 4 Flange assembled on the spindle
5.2 ELECTRICAL CONNECTION AND FUNCTIONING TESTS
ALL WORK ON THE ELECTRICAL SYSTEM, EVEN OF A MINOR NATURE,
MUST BE CONDUCTED BY PROFESSIONALLY QUALIFIED PERSONNEL !
·
Check that main tension is the same as on the rating plate; DO NOT CONNECT THE MACHINE if the
two don't match.
· The machine supply cable (supplied) is fitted with CE standard plug.
· Connect up supply cable to connector located on the back of the machine and insert plug into
main socket
· Check earth connection.
· Supply protection down stream of the plug-socket connection is the user’s responsibility. A fuse or
automatic safety
switch or cut-of f with minimum 3 mm contact break in conformity with European standards can
be used. The safety fuses of the power socket must be 3A for 230VAC machines and 6A for 115VAC
machines.
· Start up the machine by throwing the main switch (1 in Fig. 1).