L. Polyphony
Poly/Mono
Selects polyphonic or monophonic mode.
M. Octave Shift
LATCH
Shifts 1 octave and holds new value when pedal is released
SINGL
Shifts 1 octave but reverts when the pedal is released.
N. Sustain Mode
(only HOLD works with
internal sounds)
HOLD
– Holds off sending out MIDI note off messages until pedal is
released then all note off messages are sent.
MIDI CC 64
– On/Off switch that controls sustain.
MIDI CC 66
– Only holds notes that were 'On' when the pedal was pressed.
Use it to 'hold' chords and play melodies over the held chord.
MIDI CC 69
– Notes fade out according to their release parameter rather
than when the pedal is released.
O. Overlay Mode
ON/OFF
Turns the instrument overlay on or off
P. Overlay Settings
Goes to Overlay Settings screen below.
A. Bottom key
Strike a key to set the bottom limit of instrument overlay.
B. Top Key
Strike a key to set the top limit of instrument overlay.
C. Program
1-128 (0-127)
D. Channel
1-16 (0-15)
E. Note Length
0.01-8.00
Sets default Note Length for overlay.
F. Bank
1-16 (0-15)
G. Octave
0, 12, 24, 36, 48, 60, 72, 84, 96, 108
Set the starting MIDI Note Number of the 'bottom limit' in steps of 12
H. Semi-tone
0-11
Offset the starting MIDI Note Number of the 'bottom limit' in steps of 1.
I. Layer Type
OFF
-
dead zone – the overlay area does not send MIDI messages
COMB
-
instrument will output two 'note on' messages (layered)
EXCL
-
instrument will only output Overlay MIDI 'note on' messages (split keyboard)
Q. Trigg Settings
Goes to Drum trigger settings below. Drumpads are
activated
by selecting
Drumpad in Global Settings B. -
A
. Input and also Patch Settings U. Jacks 1-
4 Functions and select M. Drum Trigger.
A. Program
1-128
B. Channel
1-16
C. Pad Note number
1-128
D. Note Length
0-8000
E. Bank
1-16
PRESS 'EXIT' AT ANY TIME TO GET OUT OF A SCREEN.
R. Patch Name
^
ACOUSTIC GRAND
PIANO
Spells out Patch name using patch and octave shift
buttons by scrolling through A-Z, blank space, 0-9,
blank space, a-z, blank space, various symbols,
blank space and back to A-Z.
S. Copy to Patch
Copy Patch 00X to
XXX
Copies patch settings to another patch
T. Dynamic Gain
You can vary the sensitivity of the whole keyboard as well as relative to
pitch. Range is 0.1-9.9. 1 is normal or a gain of 1. 9.9 is a gain of 9.9.
A. Toggle ON/OFF
OFF
B. Bottom Key Gain
0.1 - 9.9
C. Top Key Gain
0.1 - 9.9
U. Jacks 1-4 Function
◄ Expression Pedal 1►
A. WMI Dampening
Note length control on the foot (half dampening)
B. Patch Up
⌂
Allows foot control of patch up.
12
