Installation:
1. Locate a structural steel beam flange capable of withstanding a 5,000-lbf. static load or
meeting OSHA requirements for a safety factor of two.
2. Push in on the latch handle to allow the adjustable hook to move.
3. Keeping the unit perpendicular to the beam, fit the hooks over the edges of the beam flange.
4. Slide the adjustable hook so that both hooks are snug against the beam flange.
5. Pull back the adjustable hook to ensure the ratchet teeth are fully seated in the nearest
ratchet notches.
6. Tug, rock, and twist the anchor in all directions to ensure that it cannot come off of the flange.
*Always re-adjust according to Installation steps 1-6 when moving to a new or different
sized beam.
** D-ring is centered on the anchorage connector for ease of sliding on beam flanges.
Particularly in rope access applications, bodyweight may disengage the centering feature
in some loading conditions. This is not a safety concern, but it may affect usability.
Adjustable Directions
Notches
Latch Handle
Notches
Latch Handle
Adjustable Hook
Adjustable Hook
PERFORMANCE:
Minimum Breaking Strength:
5000-lbf (22kN)
Maximum Capacity:
One worker when
used as a single point anchorage connector
for personal fall arrest or restraint system
DIMENSIONS:
Weight:
3.3-lbs (1504g)
Beam Flange Width Range:
3.5 -14 inches
Beam Flange Thickness:
.25 - 1.25 inches
REGULATORY COMPLIANCE:
ANSI Z359.18 Type A, ANSI Z359.7-2019,
OSHA 29 CFR 1926.502, OSHA 29 CFR 1910.140,
EN 795:2012 Type B (CE 2777)
COMPONENT MATERIALS:
Aluminum:
Cross Bar
Bronze:
Clamps
Stainless Steel:
D-Ring Bracket
Zinc Plated Steel:
D-Ring, Spring, Hardware
