Wenger UltraStor 1, Инструкция по сборке и установке

Страница: 70 / 71

1. Align the work surface on the top of the cabinets with ½” overhang to the front, 1” to the side where
appropriate and for single cabinet islands ½” – 1” overhang on the backside. Position the rounded
corners to traffic areas or as shown on the installation drawings. Attach from the underside using
screw (#89) through the pre-drilled holes in the cabinet tops.
2. For a single island installation attach the .75 x .75 x 2 (#90) bracket to the back of the cabinet and to
the underside of the work surface. Place finished back panel over bracket.
3. For double cabinet island installation attach the .75 x .75 x 2 (#90) bracket to the sides of the two
outer cabinets on both ends of the island and to the underside of the work surface. Place finished
end cover panel over bracket.
70
T
O
S
ECURE
C
ABINETS
B
ACK
T
O
B
ACK
If cabinets are installed back-to-back in a “island” or “peninsula” formation, you must drill holes through
the back of each cabinet and secure the backs of the cabinets together.
NOTE: Make sure the cabinets are in position and level before you secure them together.
1. Using a
3
/
8
" drill, make holes 2
5
/
8
" down from the top (inside) on the back of the cabinets that are
back-to-back. These holes should be no closer than 4" from the side of the cabinet. Drill through the
back of the opposite cabinet.You may also need to make holes 2
1
/
2
" up from the bottom of the cabinets.
2. With a plastic mallet, pound
1
/
4
-20 screw inserts (#9 oyster) from the inside of one of the cabinets.
Have someone inside the opposite cabinet install 1.77" hex-socket screws (#56) and tighten.
Item Description
9 insert, screw,
1
/
4
-20
(oyster)
56 screw, hex-socket, 50 mm
Connecting Holes
(sides of cabinets — see page 58)
Connecting Holes
(backs of cabinets)
T
O
S
ECURE
C
ABINETS
(
CONTINUED
)
T
O
I
NSTALL
W
ORK
S
URFACE
T
OPS
(C
ABINETS
50 - 62)
1. Align the work surface on the top of the cabinet with
1
/
2
" overhang to the front and 1” to the side where
appropriate. Position the rounded corner to traffic areas or as shown on submitted or installation
drawings. Attach from the underside using screw (#89) through the pre-drilled holes in the cabinet top.
2. #62 cabinet Insert the drawers into drawer glides.
T
O
I
NSTALL
W
ORK
S
URFACE
T
OPS AS AN ISLAND
(C
ABINETS
50 - 62)
Single Cabinet Island
Double Cabinet Island
Island Bracket