16
Installation (continued)
Connect Locker Backs Together (island mount lockers only)
NOTE:
If lockers are installed in a back-to-back configuration, two holes must be drilled through
both lockers to secure the adjacent backs together�
NOTE:
Make sure the locker sides are secured together before attaching them back-to-back�
1� From inside one locker, drill two 3/8" holes 3" down
from the top of the inside through the backs of both lockers�
These holes should be a minimum of 4" in from
the sides of the locker�
2� Use a plastic mallet to pound
1/4-20 insert nuts (11) from the inside
of one of the lockers and install
1/4-20 x 1�77" machine screws (10)
from the other side and tighten�
3� Skip to page 18�
This procedure is for securing the backs of adjacent island mount lockers.
The sides of the lockers must already be connected as described on the previous page.
This instruction is for standard installation only.
For seismic installation, see the instructions included with the Seismic Island Kit 243A028.
STOP
In an island configuration, the adjacent locker backs must
also be connected in addition to the sides of the lockers.
!
CAUTION
3" Down from
inside top
Minimum of
4" from
inside edges
1/4-20
Insert Nut
(11)
1/4-20 x 1.77"
Machine Screw
(10)
Drill through
both lockers