16
Wall Configuration Installation (continued)
18. Attach the Top Starter Connector to the Extension Connector and the
Bottom Front Wall Starter Tube to the Wall Front Extension Connector using
one 1/4-14 x 3/4” Self-Tapping Screw (5).
Position the Screw 1” (2.5 cm) from the edge of the Starter Connector.
19. Attach the Support Legs to the lockers.
a. With the pilot hole tab facing out from the lockers, place one Support Leg at each end
of the bank of lockers.
Position the Support Legs to fit under the Wall Starter Tube and Front Extension Connector
and to be 1” (2.5 cm) in from the end of the tubes.
b. Evenly space additional Support Legs under the bank according to the installation drawings.
Note:
The Support Legs should not be spaced more than 48” (122 cm) apart.
c. Unscrew the Adjustable Feet to be tight against the floor.
Mark the location of one hole on each of the feet.
Note:
Only one hole need to be marked, choose the most accessible hole.
d. Remove the Support Legs from the lockers and drill pilot holes into the marked floor locations.
e. Reposition the Support Legs back to their original position. Secure each Adjustable Foot
into the floor pilot holes using the appropriate fasteners and method described in the
“Fasteners - Not Supplied” section.
f. Attach the top of the Support Legs to the Wall Starter Tube and Front Extension Connectors
using 1/4-14 x 3/4” Self-Tapping Screws (5).
Mark the most
accessible hole
1/4-14 x 3/4”
Self-Tapping
Screw
(5)
1”
(2.5 cm)
1/4-14 x 3/4”
Self-Tapping
Screw
(5)
1”
(2.5 cm)
1/4-14 x 3/4”
Self-Tapping
Screw
(5)
1”
(2.5 cm)
Bottom Grilles are shown
removed for clarity.
