Wen TC0714, Инструкция по эксплуатации, Страница: 13 / 20

OPERATION
13
TILLING (CONT.)
3. Connect to the power supply and hold the tiller firmly
when starting. The tines will pull the tiller forward during
operation (Fig. 10).
4. To start the tiller, press the safety lock button (Fig. 8 - 1)
and then pull the trigger lever (Fig. 8 - 2) up and against the
handle bar. The motor will start and the tines will begin to
rotate.
5. When finished with the tilling session, replace the wheel
support assembly for ease of mobility and storage. Fasten
the wheel support bar to the tine guard using the M5x16
bolt, washer, and lock knob.
NOTE: For breaking sod or deep tilling, allow the tines to
pull the tiller forward to the end of your arm’s reach, then
firmly pull it back towards yourself. Best results will be
achieved by repeatedly allowing the tiller to move forward
and pulling it back.
CAUTION! Take extra precautions when moving backwards and when pulling the tiller back towards
yourself to avoid tripping.
NOTE: If tiller digs deep enough that is gets stuck, gently rock from side to side until it starts to move forward again.
WARNING! Never pass the tiller over the extension cord. Make sure the cord is always in a safe position
away from the tines.
CAUTION! When working on inclines, always stand diagonally to the incline to retain a firm, safe footing.
Do not work on extremely steep slopes.
For preparing seed beds, we recommend using one of the following tilling patterns:
Tilling Pattern A: Make two passes over the area to be
tilled, the second perpendicular to the first (Fig. 11).
Tilling Pattern B: Make two passes over the area to
be tilled, the second overlapping the first (Fig. 12).
Fig. 10
Fig. 11 Fig. 12