Wen TC0714, Инструкция по эксплуатации, Страница: 11 / 20

11
ASSEMBLY & ADJUSTMENTS
ASSEMBLING THE WHEELS
1. Remove M5x12 screws (Fig. 4 - 1) and washers (Fig. 4 - 2) from each side of wheel frame. Insert wheels (Fig.
4 - 3) onto axle (Fig. 4 - 4) of wheels frame. Fasten wheels on wheel frame with M5x12 screws and washers.
2. Press the two hub caps (Fig. 5 - 1) into each of the two wheels.
3. Attach the wheel frame (Fig. 6 - 1) to the motor guard using the M5x16 screw, washer, and lock knob (Fig. 6 - 2).
ASSEMBLING THE HANDLE
1. Insert lower handle section (Fig. 1 - 1) into motor housing (Fig. 1 - 2) and fasten using two M4x16 screws.
2. Attach center handle section (Fig. 1-3) to lower handle sections (Fig. 1-1) with two M6x45 bolts and handle knobs.
3. Fasten upper handle section (Fig. 2 - 1) to center handle section using two M6x45 bolts and handle knobs.
4. Secure the cable along the handle tubes with the two supplied cable clips (Fig. 3 - 1).
BEFORE EACH USE:
1. Check the product, its power cord and plug, and any other accessories for damage. Do not use the product if it
is damaged or shows wear.
2. Double check that the accessories and attachments are properly fitted.
3. Ensure that the handles are dry to ensure a secure grip. Always hold the product by its handles.
4. Ensure that the air vents are always unobstructed and clear. Blocked air vents may lead to overheating and dam-
age the product.
Fig. 1 Fig. 2 Fig. 3
2
1
3
1
1
Fig. 4 Fig. 5 Fig. 6
2
1
3
4
1
2
1
1