Wen SB24E, Инструкция по эксплуатации, Страница: 18 / 44

19 18
Before starting the snow blower, make sure you have read and performed the steps in the “Snow Blower Prepara-
tion” section of this manual, pages 15-17. If you are unsure about how to perform any of the steps in this manual
please call 1-800-232-1195 (M-F 8-5 CST) for customer service.
STARTING YOUR SNOW BLOWER
DANGER: CARBON MONOXIDE
Using a snow blower indoors CAN KILL YOU IN MINUTES . Snow blower exhaust contains carbon monoxide
(CO). This is a poison gas you cannot see or smell. If you can smell the snow blower exhaust, you are breathing
CO. But even if you cannot smell the exhaust, you could be breathing CO.
NEVER use a snow blower inside homes, garages, crawl spaces, or other partially enclosed areas. Deadly
levels of carbon monoxide can build up in these areas. Using a fan or opening windows and doors does NOT
supply enough fresh air. ONLY use a snow blower outside and far away from windows, doors, and vents. These
openings can pull in snow blower exhaust.
Even if you use a snow blower correctly, CO may leak into the home. ALWAYS use a battery-powered or battery-
backup CO alarm in the home. If you start to feel sick, dizzy, or weak after the snow blower has been running,
move to fresh air RIGHT AWAY . See a doctor. You may have carbon monoxide poisoning.
WARNING: The exhaust from this product contains chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
WARNING: Do not operate snow blower near open flame or flammable materials This snow blower may
emit highly flammable and explosive gasoline vapors, which can cause severe burns or even death if ignited.
A nearby open flame can lead to explosion even if it isn’t directly in contact with gasoline. Do not smoke near
the snow blower.
BEFORE STARTING YOUR SNOW BLOWER
1. Verify that the snow blower is outside on a level sur-
face with at least 2 feet of clearance on all sides.
2. Check that there is a sufficient level of oil in the crank-
case. Add oil if necessary, see "Step 1 - Add/Check Oil
(Fig. 10 & Fig. 11)" on page 15.
3. Check that there is a sufficient level of gasoline in the
fuel tank. Add fuel if necessary, see "Step 2 - Add/Check
Fuel (Fig. 12)" on page 16.
4. Check that the chute and deflector plate are pointing
in the desired direction. Adjust the chute and deflector
if necessary, see "Step 3 - Adjust The Chute & Deflector
Plate (Fig. 13 & Fig. 14)" on page 17.
STARTING THE SNOW BLOWER
1. Release the lever (right side). Put the shift lever in the
low, forward position (Fig. 15 - A).
2. Push the fuel switch (Fig. 16 - A) to the ON position.
FORWARD REVERSE
FAST FAST SLOW
Fig. 15
Fig. 16
A
A