Wen PW20, Руководство пользователя

Страница: 8 / 14

PREPARING AND RUNNING THE PRESSURE WASHER
Position the pressure washer as close to the water supply as possible. Make sure that the washer is standing on a
secure, stable surface to prevent it from tipping during operation. Connect the water supply hose to the water inlet
adapter. If you prefer, you can detach the water inlet adapter from the unit first to make it easier attach to the gar-
den hose. After the adapter has been securely attached to the hose, you can then attach the coupler to the pressure
washer.
After the hose has been properly fastened to the pressure washer’s water inlet adapter, turn on the water supply tap.
Make sure its open as far as it can go.
Release the safety lock of the gun and press down on the trigger for a few seconds to allow air to escape from the
gun and the hose. While keeping the trigger pressed, turn the power switch on the pressure washer, making sure
the lance is not aimed away from any bystanders or animals.
Once the flow has increased to its maximum rate, aim the stream at the desired surface and start cleaning.
SHUTTING DOWN THE UNIT
Once a job has been complete, turn the power switch to the off position and unplug the cord from its power source.
Next, turn off the water source. Finally, hold down the trigger switch to relieve any built up pressure. After this, all
hoses can be disconnected. Always engage the gun safety lock before storing the pressure washer.
8
OPERATION
CONNECT HIGH PRESSURE HOSE TO PUMP
1. Attach the end of high pressure hose to the high pressure outlet on pump.
2. Follow the same procedure with opposite end to attach high pressure hose to spray wand.
CONNECTING GARDEN HOSE TO PRESSURE WASHER
1. Run water through the hose for a few seconds to flush any debris from the hose.
2. Inspect the inlet screen and remove any debris.
3. Connect hose to water inlet and tighten by hand. Make sure the hose is off while connecting it to the unit.
There must be a minimum of 10 feet of unrestricted hose between pressure washer and faucet or shut off valve.
4. Turn on water.
5. Purge the system’s pump of air by releasing the safety and squeezing the trigger of the spray gun.
Fig. F