Wen BG4260, Инструкция по эксплуатации

Страница: 10 / 20

POSITIONING THE MACHINE
Place the machine on a stable, flat work surface. The ma-
chine has four rubber feet pre-installed to increase stability
and reduce vibration. Make sure there is sufficient open
space around the machine. Route the power cord so that
it will not make contact with the bench grinder's moving
parts.
INSTALLING THE TOOL RESTS (FIG. 2)
1. Place the left tool rest (A) over the tool rest bracket (C)
and align the slots.
2. Slide the carriage head tool rest screw (B) through from
the left side. Screw the tool rest knob (D) onto the carriage
bolt to hold the tool rest in place.
3. Adjust the tool rest within 1/16 inch of the grinding
wheel. To adjust: loosen the knob, shift the tool rest, then,
tighten the knob.
4. Repeat on the right side.
INSTALLING THE SPARK DEFLECTOR (FIG. 3)
1. Place the spark deflector (B) against the left wheel guard
(A) (with the thick portion on the bottom). Align the slot
with the hole on the wheel guard. Adjust the spark deflector
within 1/16 inch of the grinding wheel.
2. Use a Phillips-head screwdriver to secure the pieces to-
gether with the spark deflector screw assembly (C).
INSTALLING THE EYE SHIELD ARM (FIG. 3)
1. Attach the left shield arm (D) to the inner left wheel
guard using a bolt (G), lock washer (F), and flat washer (E)
to secure it into place.
2. Repeat on the right side.
INSTALLING THE EYE SHIELD (FIG. 4)
1. Attach the left eye shield (A) to the left shield arm and
tighten the locking knob (B) to hold the shield in place.
2. Repeat on the right side.
ASSEMBLY & ADJUSTMENTS
10 10
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read
through and become familiarized with the following procedures of handling and adjusting your tool. Failure to
follow the safety instructions may result in serious personal injury.
Fig. 2
Fig. 3
Fig. 4
A
B
C
D
A
B
C
D E
F
G
A
B