Wen 61793, Руководство пользователя

Страница: 6 / 18

28. DO NOT DISCHARGE fasteners into open air, concrete, stone, extremely hard woods, knots or any
material too hard for the fastener to penetrate.
29. DO NOT DRIVE FASTENERS near the edge of your work material. The workpiece may split, causing the
fastener to ricochet, injuring you or a bystander. Be aware that the nail may follow the grain of the wood, causing
it to protrude unexpectedly from the side of the work material. Drive the nail perpendicular to the grain to reduce
risk of injury.
30. DO NOT DRIVE NAILS onto the heads of other fasteners. Do not use the tool at too steep of an angle.
Personal injury from strong recoil, jammed fasteners, or ricochetted nails may result.
31. BE AWARE OF MATERIAL THICKNESS when using the nailer. A protruding nail may cause injury.
32. KNOW that when the tool is being utilized at pressures on the high end of its operating range, nails can be
driven completely through thin or very soft work material. Make sure the pressure in the compressor is set so that
nails are set into the material and not pushed completely through.
33. REMOVE FINGER FROM TRIGGER when not driving fasteners. Never carry the tool with your finger on
the trigger.
34. IF THE FASTENERS ARE JAMMED, disconnect the tool from the air supply first before removing the
jammed fasteners.
35. DISCONNECT tool from air supply when not in use. Remove fasteners from magazine before leaving the
area or passing the tool to another operator. Do not climb ladders, stairs, scaffoldings, etc. without disconnecting
the tool. Do not carry a connected tool to another work area. Do not make adjustments, remove magazine,
perform maintenance or clear jammed fasteners while connected to the air supply. If the safety bracket is adjusted
when the tool is connected to the air supply with loaded nails, accidental discharge may occur.
36. DO NOT REMOVE, tamper with, or otherwise cause the tool, trigger or safety bracket to become
inoperable. Do not tape or tie the trigger or safety bracket in the ON position. Do not remove springs from the
safety bracket. Make daily inspections for free movement of the trigger and safety bracket. Do not alter or modify
the tool in any way.
37. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow
instructions for lubricating, changing accessories and storage.
NOTE:
The warnings, cautions, and instructions explained in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product, but must be supplied by the operator.
SAFETY RULES
6