Wen 61793, Руководство пользователя, Страница: 11 / 18

ADJUSTING THE DRIVING DEPTH (Fig. 8)
Make sure to disconnect the air supply and remove fasteners from maga-
zine before making adjustments. The driving depth is set to the maximum
from the factory. Adjust the driving depth using the following steps.
1. Loosen the depth lock screw (Fig. 8 - 1) using the hex key.
2. Slide the safety bracket (Fig. 8 - 2) to adjust the firing depth. Sliding the
bracket upward increases the driving depth and sliding the bracket down-
ward decreases the driving depth. Retighten the depth lock screw.
NOTE:
Adjust the air pressure regulator along with the depth setting so
that the desired driving depth can be achieved with the lowest possible air
OPERATION
WARNING:
Hearing and eyes protection must be used
drive a fastener. Reposition the nailer and disengage either the trigger or the safety bracket between shooting mul-
tiple nails.
NOTE:
Unit may spark when nails are fired, this is normal.
WARNING:
Do not fire another nail over the position of the existing nail, as the nail may bounce back
and cause serious injury.
4. The nailer is equipped with an anti-dry-fire mechanism to protect your nailer from firing blank shots. When the
remaining quantity of fasteners is less than five, reload the magazine according to “Loading the Fasteners” on page 9.
5. After operation, turn off the air compressor and depressurize the compressor according to the instructions in-
cluded with your compressor. Disconnect the air hose from the nailer.
1. Check that the air supply is correctly connected to the tool at
the correct pressure and the fasteners have been properly load-
ed into the magazine.
2. Hold the nailer upright on the workpiece and position the
safety bracket where the fastener will be driven (Fig. 8).
3. For Sequential Trigger: Press down the safety bracket and
pull the trigger to drive a fastener. Reposition the nailer and dis-
engage the trigger between shooting multiple nails.
For Contact Trigger: Press down the safety bracket and pull the
trigger or pull the trigger and press down the safety bracket to
11
Fig. 9
90°
Fig. 8
SHOOTING NAILS (Fig. 9)
WARNING:
User must wear proper eye and hearing protection when operating this tool. Stay alert and
keep proper balance at all times. Keep your fingers away from the trigger when not operating the nailer
to reduce the risk of unintended nail discharge.
WARNING:
Never attempt to drive a fastener into materials that is too hard, or at a steep angle, or near
the edge of the workpiece. The fastener can ricochet and cause serious personal injury.
pressure. This will save energy, reduce noise level and reduce the wear on the tool.
1
2