ASSEMBLY & ADJUSTMENTS
CHUTE CRANK ASSEMBLY
1. Locate the upper chute crank in the parts bag.
Loosen the thumb screw (Fig. D - 1) located on
the lower chute crank (Fig. D - 2) that comes pre-
attached to the body of the snow thrower.
2. Slide the upper chute crank (Fig. D - 3) through
the grommet (Fig. D - 4) in the middle frame assem-
bly into the lower chute crank, lining up the holes in
each respective part of the crank to allow room for
the thumb screw.
3. Screw the lower crank’s thumb screw in through
both the lower and upper chute crank. Test the crank,
turning it clockwise to make the chute turn left and
counterclockwise to turn right.
NOTE:
If things aren’t lining up as they should, check
to make sure that your middle frame assembly is
on correctly. As mentioned earlier, the grommet and
thread of the middle assembly should be facing up-
wards, but I bet you didn’t even read that part of the
instructions did you. I work so hard on these manu-
als and to what avail...
Fig. D
1
2
3
4
OPERATION
SECURING THE EXTENSION CORD (FIG. E)
For safe and efficient use of your snow thrower, only use a UL-rated extension cord
that meets the gauge needs to operate a 13.5A snow thrower.
To prevent the extension cord from disconnecting during operation, fold the fe-
male end of the extension cord in half and slide it through the plastic extension
cord wrangler found hanging from the upper frame assembly. Place the folded half
of the cord around the wrangler’s hook and pull down to secure it in place. This
should help prevent the cords from becoming unplugged.
Note that the snow thrower has a polarized male plug with one prong slightly
longer and wider than the other. The female end of the extension cord should be
similarly polarized so the cord fits snugly into the switch-housing socket.
TURNING THE SNOW THROWER ON AND OFF
To power the snow thrower on, first plug it into the proper power source. To start the rotation of the auger, press
and hold the safety switch found on the outside of switch housing on the upper frame assembly.
While pressing down on the safety button, pull the handle bar towards you and grab hold of it firmly to start the
machine. When the motor is on, release the switch button and hold the handle bar with two hands.
To power the snow thrower off, release your grip on the handle bar.
Fig. E
9
Содержание 5662
Страница 12: ...12 EXPLODED VIEW PARTS LIST...
Страница 15: ...15 NOTES...
Страница 16: ...THANKS FOR REMEMBERING V 2021 06 21...