Wen 56455i, Инструкция по эксплуатации

Страница: 35 / 52

MAINTENANCE
BATTERY MAINTENANCE/STORAGE
The lithium-ion battery will receive charge when the engine is running. Remember to run the generator once a
month for 20-30 minutes to charge the battery. A charged battery will allow you to start the generator us¬ing the
electric start button during your next time of need. If the battery is out of charge, you may start the generator using
the recoil starter. If the generator is not used for a long period, it is recommended to disconnect the negative (black)
battery cable from the battery to protect it from losing charge. After disconnecting the cable, cover the free end with
an insulator such as electrical tape.
TIP: You can also connect the battery to an automatic trickle charger to keep the battery charged. If using a trickle-
charger, charge the battery at room temperature.
Lithium-ion batteries can be damaged or suffer a shortened lifespan if they are charged in very cold temperatures
(below freezing). If you expect to store the generator in temperatures below 25°F (-5°C), we recommend removing
the battery from the generator and storing it indoors. If using the generator in temperatures below 25°F (-5°C), we
recommend running the generator for at least 15 minutes with the battery removed, or the negative (black) battery
cable disconnected and covered with an insulator such as electrical tape, and then connecting the battery. This will
allow the inside of the generator to warm up, and will greatly reduce the chance of damage to the battery.
To reinstall/replace the battery:
1. Using a quarter coin or flat-head screwdriver (not includ-
ed), open and remove the battery access cover (Fig. 33).
2. Loosen the rubber belt and pull out the battery (Fig. 34).
3. Disconnect negative (-) battery terminal first (black cable).
4. Disconnect positive (+) battery terminal second (red cable).
5. Replace with an identical new battery (part no. 56380i-
1304).
6. Connect the positive (+) battery terminal (red cable) first.
Slide rubber boot over the positive terminal.
7. Connect the negative (-) battery terminal (black cable)
sec¬ond. Slide rubber boot over the negative terminal.
8. Return the battery into position and use the rubber belt to
fasten the battery.
9. Reinstall and secure the battery access cover.
NOTE: Always recycle used batteries in accordance with local
laws and regulations. Contact your local solid waste collection
site or recycling facility to obtain information on local recy-
cling processes.
Fig. 29
Fig. 30
Rubber Belt
Battery
Access
Cover
WARNING! It is best to store the battery indoors at room temperature. Do not store your battery outside in
the winter, where temperatures may go below 25°F (-5°C), or in any location where temperatures may exceed
104°F (40°C), such as in direct sunlight or inside a vehicle or metal building during the summer.
35