Wen 48107, Руководство пользователя, Страница: 10 / 16

MAINTENANCE
WARNING
: To avoid accidents, always disconnect the tool from the power supply before cleaning or
performing any maintenance. Servicing of the tool must be performed by a qualified technician.
CLEANING AND STORAGE
1. Wipe the tool after every use with a soft cloth or low-pressure compressed air. Do not let water enter the tool.
2. Keep the ventilation openings free from dust and debris to prevent the motor from overheating.
3. Most plastics are susceptible to damage from various types of commercial solvents Do not use any solvents or
cleaning products that could damage the plastic parts. Some of these include but are not limited to: gasoline, carbon
tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.
4. Store the tool in a clean and dry place away from the reach of children.
Carbon Brush
Length
Carbon Brush
Cover
10
PRODUCT DISPOSAL
Used power tools should not be disposed of together with household waste. This product contains electronic com-
ponents that should be recycled. Please take this product to your local recycling facility for responsible disposal and
to minimize its environmental impact.
CARBON BRUSH REPLACEMENT
The wear on the carbon brushes depends on how frequently and how
heavily the tool is used. To maintain maximum efficiency of the motor, we
recommend inspecting the two carbon brushes every 60 hours of operation
or when the tool stops working.
NOTE:
Replacement carbon brushes (Part No. 48107-022) can be or-
dered at wenproducts.com. Only genuine WEN replacement brushes
designed specifically for your tool should be used.
1. To access the carbon brushes, remove the carbon brush covers on the
left and right side of the motor housing.
2. Carefully remove the carbon brushes using pliers. Keep track of which
orientation the old carbon brushes were in to prevent needless wear if they
will be reinstalled.
3. Measure the length of the brushes. Replace the brushes if either carbon
brush length is worn down to 3/16 of an inch. Both carbon brushes should
be replaced at the same time.
4. Install the carbon brushes and the carbon brush covers.
NOTE:
New carbon brushes tend to spark for a few minutes during the first use as they wear down.