12
11
10
2
31
Fig. 1
Fig. 2
INSTALLING THE BRACKETS (FIG. 3)
INSTALLING THE HANGERS (FIG. 3)
ATTACHING THE RUBBER FEET
REMOVE THE STYROFOAM BLOCKS (FIG. 1 & 2)
1. Attach the mounting bracket (Fig. 3 - 2) using two
M6x12
bolts (Fig. 3 - 3), two M6 lock washers (Fig. 3 - 4) and two
M6 flat washers (Fig. 3 - 5).
2. Tighten bolts securely using a socket or wrench (not in-
cluded). Repeat for all four mounting brackets.
2
1
3
4
5
1. Thread a mounting hanger (Fig. 3 - 1) into the mounting
hole on the top of the air filter cabinet.
2. Rotate the hanger clockwise to fully tighten it into the hole.
Repeat for all four hangers.
The four rubber feet can be attached onto the base of the
unit if the machine will be placed on a benchtop.
1. Lift up the filter lock clips on the back of the machine to
remove the outer filter and inner filter.
2. Remove the inner grating (Fig. 2 - 1) by unscrewing the six
Phillips head screws.
3. Remove the styrofoam blocks.
4. Replace the inner grating. Replace the inner and outer
filters and close the lock clips (see instructions on page 11).
The air filtration system is designed to circulate air and filter wood and other non-metallic dust. To achieve
the best performance possible, it is important to consider how and where to place the unit. When select-
ing a site, make sure there is a suitable power source nearby. The use of an extension cord is NOT recom-
mended with the air filtration system.
ASSEMBLY & INSTALLATION
WARNING:
To prevent serious injury from accidental operation, make sure the power cord is dis-
connected from the power source and the tool is switch to OFF before assembly or making any adjust-
ments.
IMPORTANT:
Styrofoam blocks (Fig. 1) are installed
around the motor to protect it from shipping damage.
They MUST be removed before operation.
8
Fig. 3
1
Содержание 3417
Страница 16: ...THANKS FOR REMEMBERING ...