Wells GAS GRIDDLES, Руководство по эксплуатации

Страница: 13 / 18

11
DO NOT REMOVE FROM MANUAL - PHOTOCOPY TO DISTRIBUTE
PREVENTATIVE MAINTENANCE CARD
STANDARD GAS GRIDDLE
CLEANING INSTRUCTIONS
PREPARATIONS:
Set temperature control to 220ºF. Allow the griddle temperature to drop to
220ºF before proceeding.
FREQUENCY: Daily
TOOLS: Griddle Brick or Pumice Stone
Fiber Brush
Plastic Scouring Pad, Plastic Scraper
Mild Detergent, Non-Abrasive Cleanser
Clean Soft Cloth / Sponge
1. Pour a small amount of water on the griddle surface and let it "sizzle".
2. Clean the griddle surface:
a.
For standard griddles, use a pumice stone or griddle brick to scrape food waste.
Clean the griddle surface down to bright metal. Wipe off any remaining
powder residue.
b. For grooved-surface griddles, use the supplied contoured scraper to scrape food
waste. Clean the griddle surface down to bright metal.
IMPORTANT: NEVER USE STEEL WOOL TO CLEAN THE GRIDDLE SURFACE!
3. Use a soft-bristled fiber brush in a circular motion to remove any remaining food particles.
4. Turn temperature control to OFF . Allow the griddle surface to cool, then wipe the surface
with a clean cloth. Dry the griddle surface thoroughly.
IMPORTANT: Season the cooking surface after each cleaning.
5. At least once each day, the grease trough must be thoroughly cleaned. Using a scraper,
remove all grease and food waste from the grease trough by pushing it down the waste
hole and into the grease drawer.
IMPORTANT: Use care not to gouge grease trough. Repeated scraping can wear
through the trough.
6. After scraping all cooking waste from grease trough into the grease drawer, take the
grease drawer to kitchen cleaning area and properly dispose of all waste.
a.
Clean drawer with hot water and a mild detergent.
b. Dry drawer thoroughly and reinstall in griddle.
7. Clean the splash guard in the sink with warm water and mild detergent, or in the dish
washer. Rinse thoroughly and reinstall.
8. Wipe down exterior of griddle cabinet with a clean cloth and non-abrasive cleanser. Rinse
thoroughly with water and a clean cloth. Dry with a soft clean cloth.
IMPORTANT : DO NOT splash or pour water onto control panel.
Procedure is complete.
PM 121.1