IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS
Notes emphasize information and/or provide additional information to assist the user.
Caution messages appear before procedures that could result in damage to equipment if not observed.
Warning messages appear before procedures that could result in personal injury if not observed.
This manual is intended to be used as a basic installation and operation guide for the Welker Pitot Probes, PP-1, PP-2, PP-3, and PP-F. For comprehensive instructions,
please refer to the IOM Manuals for each individual component. A list of relevant component IOM Manuals is provided in Appendix A of this manual.
The information in this manual has been carefully checked for accuracy and is intended to be used as a guide for the installation, operation, and maintenance of
the Welker equipment described in this manual. Correct installation and operation, however, are the responsibility of the end user. Welker reserves the right to make
changes to this manual and all products in order to improve performance and reliability.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
- Save these instructions for local inspector's use.
IMPORTANT
- Observe all governing codes and ordinances.
Note to Installer
- Leave these instructions with the end user.
Note to End User
- Keep these instructions for future reference.
Installation of this Pitot Probe is of a mechanical nature
.
Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the warranty.
If you received a damaged Pitot Probe, please contact a Welker representative immediately.
Phone:
281.491.2331
Address:
13839 West Bellfort Street
Sugar Land, TX 77498
SAFETY
3
IOM-101
MODELS: PP-1, PP-2, PP-3, and PP-F
REV: C
13839 West Bellfort Street, Sugar Land, TX 77498
welker.com
Service Department 281.491.2331
