Welker INFLOW, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 41

Completing Installation
34. Once the inFlow™ ACE is inserted and secured, use ¼" tubing to connect from the sample outlet to an appropriate
customer-supplied sample container, such as a Welker TCC Transportable Crude Oil Container.
Customer-supplied ¼" tubing must slope downward from the inFlow™ ACE to the sample container.
35.
Use appropriately sized tubing to connect from the normally open port on the solenoid to port A on the motor housing
(
Figure 2 ). Use appropriately sized tubing to connect from the normally closed port on the solenoid to port B on the
motor housing ( Figure 2 ).
The normally open port should be stamped "A" or "NO."
The normally closed port should be stamped "B" or "NC."
36.
Open emergency shutoff valve E ( Figure 1 ).
37. As necessary, adjust the external sand relief. With emergency shutoff valve E open, loosen the jam nut, tighten the
adjusting screw on the external sand relief, and then tighten the jam nut as a locking device ( Figure 13 ).
After the external sand relief valve has been set, emergency shutoff valve E must remain open during sampling. For more
information about emergency shutoff valve E, see Section 2.7, Emergency Shutoff .
The external sand relief comes factory-set by the manufacturer if requested at the time of order.
15
IOM-161 MODEL: INFLOW™ ACE WITH AI CONTROL™ REV: D 13839 West Bellfort Street, Sugar Land, TX 77498 welker.com Service Department 281.491.2331