WELDMAN
POWER PULSE DC TIG 200 HF / LIFT
4
Lp.
Description
front view
1
Multifunction knob (selection and adjustment of parameters) 2
control parameters MMA HOT START (1-10) and ARC FORCE (1-10) 3
display 4
Power LED 5
overload indicator light (alarm) 6
carrying handle (shoulder strap) 7
mode switch; MMA MMA welding GAS: free
flow of gas (test gas)
4T LIFT: TIG mode selection handle 4-stroke at the pole arc is struck (LIFT) 2T LIFT: TIG mode selection handle
2-stroke at the pole arc is struck (LIFT) 4T HF TIG mode selection handle 4T at a non-contact arc is struck (HF) 2T HF
TIG mode selection handle 2T with a non-contact arc is struck (HF) 8
control parameters and TIG TIG PULS 9
slot of positive polarity (MMA handle, a ground terminal TIG) 10
control socket TIG 5-pin of the protective cap 11
cavity of negative polarity (ground terminal MMA TIG) 12
Gas socket (quick type 21)
rear view
13, the input power cord 230V / 50Hz main switch 14 ON / OFF
15
Protective gas connection (plug for quick coupling type 21)
V. INSTALLATION
V. INSTALLATION
WORKING ENVIRONMENT
Welder set equal to (maximum angle of inclination of 15 °) and dry surface with a capacity suitable for the weight in order to avoid its overturning.
The device should be placed in a well ventilated area with free air circulation, away from flammable objects (min. Distance from other objects 0.5m). Make sure
not enter the welder dust, corrosive vapors and moisture.
The unit should be set in such a place, not to get into it from welding spatter.
CONNECTING TO NETWORK
Before the electrical connection:
•
check whether the data on the plate correspond to the values of the welding voltage and frequency of the network devices in the workplace
•
check that the mains supply for the required input power
•
check whether the fuse values are consistent with those given in the technical data
•
Check the wiring grounding welding. Welding wire is supplied with a 230V plug.
ELECTRICAL CONNECTION SHOULD BE CARRIED OUT BY QUALIFIED PERSONNEL OR EXPERIENCED
PREPARATION TO WORK:
1) Before connecting the welder to the mains, make sure that the main switch (rear panel) is in the off position
1) Before connecting the welder to the mains, make sure that the main switch (rear panel) is in the off position
2) Hollow clamp the wire mass to secure the work piece
2) Hollow clamp the wire mass to secure the work piece
3) The other end of the cable plugs into the mass of positive polarity (+) - TIG, or slot
3) The other end of the cable plugs into the mass of positive polarity (+) - TIG, or slot
of negative polarity (-) - method MMA
4) Plug the operating handle connected to the outlet of the negative polarity (-) - TIG, or slot
4) Plug the operating handle connected to the outlet of the negative polarity (-) - TIG, or slot
of positive polarity (+) - method MMA
5) To the output gas (front panel) connect the plug of the gas holder
5) To the output gas (front panel) connect the plug of the gas holder
(TIG only)
6) The slot-pin controller 5 (front panel) to connect the plug of the control handle
6) The slot-pin controller 5 (front panel) to connect the plug of the control handle
TIG welding (TIG only)
