WeldCorp MULTI PULSE PRO 240, Руководство по эксплуатации для владельца

Страница: 10 / 23

Page 9
WELDER INFORMATION (cont.)
FUNCTION RESET
Turn off the machine, the microprocessor on board stores the last welding settings
used. It also possible to reset the welding parameters restoring it to factory settings.
To reset:
1) Turn off the welding machine
2) Hold onto “ENC-1” until the welding machine is on; reset is successful if the
display shows “ooo ooo”, or retry steps 1-2
3) Release ENC-1
PROTECTION FROM OVERHEATING
The duty cycle is the fraction or percentage of a ten-minute cycle that a power
source may be used without overheating. For example, a welding machine with
150 amp - 30% duty cycle can weld continuously at 150 amps for 3 minutes and
then must cool down during the remaining 7 minutes to prevent overheating, with
the ambient temperature of 40 degrees celcius.
Using the machine with proper duty cycle according to the selected welding
current prevents overheating. If the machine stops due to overheating, both
displays will flash showing “H00” and cannot be possible to weld. You can restart
welding as soon as the “H00” signs disappear from the displays.
Turning the key on the front panel, you can choose low-power
(key position on the word “10A”) or the maximum power (key
position on the word “MAX”)