WeldCorp MULTI PULSE PRO 240, Руководство по эксплуатации для владельца

Страница: 7 / 23

Page 6
INSTALLATION
Warning: Use all precautions required in the safety general manual before
operating the welder, reading carefully the risks associated with the welding
process.
The installation must be made by the trained personnel in compliance to the
standard IEC 60974-9 and the current and local legislation. All connections must be
made in accordance with the reference standard. To lift the machine, the lifting hole
must be applied on the top of the machine. Do not use it to lift the machine at more
than 1 meter from the floor.
The input voltage must match the voltage indicated on the technical plate located
on the product. The equipment should only be used on a supply system that is
a single-phase, three-wire system with an earthed neutral. Use the machine on
electric system having supply features and power protection that are compatible
with the current required for its use. For more details see the information on the
plate placed on the machine. The machine has an IP 21S protection level.
Mounting and adjusting the gas cylinder: must be placed in the back of the
machine and secured with a chain (supplied as accessory). Assemble the pressure
reducer and adjust the output pressure of the gas between 5 & 25 litres per minute.
WELDER INFORMATION
The machine functions are controlled by the control panel on the front panel. The panel is
composed of two displays, “DISP-1” and “DISP-2” and two knobs, “ENC-1” and “ENC-2”, which
allow the rotation and the pressure.
To select the type of welding,
press “ENC-1” on “DISP-1” will
show the type of welding and
by turning it you can choose
between MMA, TIG and
MIG. Stopping the rotation
of the knob, the on-board
microcontroller automatically
selects the type of welding
displayed.