10.
Welcare PureAir Ultraviolet Desktop Air Purifier
Using the Air Purifier
Standby:
Insert the AC adaptor into the port on the main body of the Air
Purifier, then insert the plug into the wall socket. The buzzer will sound, and
all the indicators will light up. After three seconds, the Air Purifier will be in
standby mode The “power button” indicator lights up in
RED
Please note:
no other icons will light up
Power On/Off:
Tap the top power icon to switch the power on Tap again to switch the power off
The default fan speed is Mid, and the child lock will be off
Fan Speed Function:
Tap the fan speed adjustment icon to choose fan
speed - Mid
High
Sleep
Low
Sleep Mode:
When the sleep function is activated, the power, fan speed and
sleep icons will illuminate at half brightness All other icons will turn off
Child Lock:
Press the icon for three seconds to switch the child lock ON/OFF
–
If the icon light is continuous, the child lock function is turned OFF.
–
If the icon light is flashing, the child lock function is turned ON.
Replace the Filter:
When the filter has been used for approx. 6,000 hours,
the replacement filter indicator light will flash, and the buzzer will beep.
After replacing with a new filter, hold the filter reset icon for five seconds until
the light fully illuminates and no longer flashes. At the same time, the buzzer
will stop sounding. This button can also be used to turn the air quality indicator
lights on and off (by pressing once)
Timer Function:
Touch the timer icon, adjust the countdown shutdown time
1hr
2hr 4hr 8hr. The sequence will then loop.
Note:
If no timer is set, the Air Purifier will continuously operate until it is
manually switched off
Cleaning and Maintenance
The pre-filter should be cleaned every 3 months to maintain optimum performance
• When cleaning, always turn off the power and disconnect from the power source
• Clean the main body of the Air Purifier with a damp soft cloth and mild detergent if
required. Dry with a soft cloth.
•
DO NOT
use any harsh chemical cleaning agents
• Remove the pre-filter, use a vacuum cleaner to absorb the dust around the
circumference of the pre-filter.
•
ONLY
the pre-filter can be cleaned with water.
• The HEPA (H13) filter and UV-C LED light
CANNOT
be cleaned
WPA200_Instruction-Manual_A5-working.indd 10
WPA200_Instruction-Manual_A5-working.indd 10
5/9/2022 4:58 pm
5/9/2022 4:58 pm
