Welbilt Manitowoc LuminIce II, Инструкция по установке, эксплуатации и обслуживанию

Страница: 27 / 30

Part Number: 000014110 Rev 01 1/19 27
Section 3 Maintenance
If vacuuming is needed to ensure removal
of all broken glass, keep the following tips
in mind:
• Keep a window or door to the outdoors
open.
• Vacuum the area where the bulb was
broken using the vacuum hose, if
available; and remove the vacuum bag
(or empty and wipe the canister) and
seal the bag/vacuum debris, and any
materials used to clean the vacuum, in a
plastic bag.
• Promptly place all bulb debris and
cleanup materials, including vacuum
cleaner bags, outdoors in a trash
container or protected area until
materials can be disposed of properly.
• Check with your local or state
government about disposal
requirements in your area. Some states
and communities require fluorescent
bulbs (broken or unbroken) be taken to a
local recycling center.
• Wash your hands with soap and water
after disposing of the jars or plastic
bags containing bulb debris and cleanup
materials.
• Continue to air out the room where the
bulb was broken and leave the H&AC
system shut off, as practical, for several
hours.
Cleanup Steps for Carpeting or Rugs
1. Carefully scoop up glass fragments and
powder using stiff paper or cardboard
and place debris and paper/cardboard
in a glass jar with a metal lid. If a glass
jar is not available, use a sealable
plastic bag.
NOTE: Since a plastic bag will not prevent
the mercury vapor from escaping, remove
the plastic bag(s) from the home after
cleanup.
2. Use sticky tape, such as duct tape,
to pick up any remaining small glass
fragments and powder. Place the used
tape in the glass jar or plastic bag.
NOTE: Vacuuming of hard surfaces during
cleanup is not recommended unless broken
glass remains after all other cleanup
steps have been taken. It is possible
that vacuuming could spread mercury
containing powder or mercury vapor,
although available information on this
problem is limited.