Weka 612.3260.30.00, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 5 / 44

Technische Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.

Copyright HRB 3662
4

your own alterations to the product

defective care in the maintenance of the current wood quality

prevailing winds in excess of force 7 (stiff wind)
Inland, consequences such as the movement of whole trees and any noticeable
impedance when walking in the open air are to be observed. No defects due to
these conditions will give rise to a guarantee.

Natural catastrophes or other violent occurrences.
Fluctuations in colour, crack formation, warping or similar changes which are completely
normal outdoors are no grounds for making a claim.
Further claims and consequential damage do not fall under the guarantee regulations. Our General
Terms and Conditions apply.
NOTE! For retrofitting of wall elements, equipment and storage rooms, or other wall coverings,
constant and full-surface ventilation underneath the roof panels is required, as otherwise heat
may be built up and the roof panels damaged.
For this, a minimum distance of 20 cm up to the roof panels must be ensured.
NOTES – ROOF TILES

Prior to mounting, the roof tiles are to be stored undercover and out of direct sunlight. This applies
in particular to white foils. Heat may build up under a stack of tiles leading to distortion and
discoloration of the tiles due to the burning glass effect.

Roof tiles must not be mounted in temperatures below +5°C or above 30°C.

In order to guarantee the impermeability of your car port, silicon is to be used when laying the roof
tiles (not included in the delivery.

The roof tiles are to be pre-drilled with holes with a diameter = 10 mm.

Please note that the screws are not to be screwed down too tightly in order to guarantee the
function of the tiles.

Note: No false floor may be installed or thermal insulation provided below the roof tiles. There
must be adequate ventilation beneath the roof tiles.
TOOL
You should have the following tools to hand before beginning assembly. (Not supplied.)
Spring tape measure Spirit level Pencil Mitre saw/hand disk saw
Drill Electric screwdriver Taper drill Screw clamp
Spanner
= Entrance
Il est conseillé de vérifier et de resserrer les assemblages vissés à intervalles réguliers. Ce produit est
essentiellement fabriqué en bois massif. Le bois étant un matériau naturel, il se peut que des
conditions climatiques extrêmes, notamment après de longues périodes de chaleur, entraînent la
formation de fentes de sécheresse. Ces fentes de sécheresse ne constituent en aucun cas un défaut
de qualité, mais un phénomène naturel. Selon la situation météorologique, ces fentes peuvent se
refermer quasi-intégralement.De plus, ces fentes de sécheresse, qui apparaissent dans le bois dans
le sens de la longueur, n'exercent aucune influence sur la solidité et la résistance du matériau.
Autrement dit, les propriétés statiques ne sont pas affectées.