Weka Holzbau 593.3131 Series, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 21 / 72

Technische Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.

Copyright HRB 3662
20
Important:
Remain in the pool until the base is smooth
. Should there be any wrinkles in the walls,
these can now be overcome through adjustment. The wrinkle-free positioning of the liner is to be
constantly checked as filling of the pool continues.
8) When the water level is 2/3 full and the walls are wrinkle-free, the liner can be permanently fixed to
the upper, outer edge of the wooden wall. The cover profiles are then mounted to complete the
upper wall. The inlet nozzle and the skimmer are installed when the water is around 5-6 cm below
their opening. Only then is the liner cut appropriately to the opening at this point. After installation of
the inlet nozzle, skimmer and the necessary connection tubes, the pool can be filled again. For
information on the installation and operation of your filter system, please refer to the enclosed
instructions.

Cover
When using a cover (not included in delivery), we recommend that you use the screw hooks to fasten the
cover. Install as shown in the last diagram. The cover should lie loosely on the surface of the water, not taut
and not pulled over the pool corners.
Information: The covers are not suitable for use during overwintering.
5.6. Tools
Please drill pilot holes for all screw connections
to avoid damaging the wood.
The following symbols in the instructions will indicate when this is necessary:
You should have the following tools to hand before beginning assembly:
Tape measure Drill Electric screwdriver Hammer Pencil Burring iron Rubber mallet
Saw Universal cutter Cord Spirit level Spanner
Vice
5.7 Abbreviations
-
RW = Rear wall
-
WS = Wall thickness
- FR -