Shenzhen Weistek Technology Co., Ltd. www.weistek.net
18
7.2 Print Filament Test
【
take PLA for instance
】
Connect power supply, turn on printer, operate on operation panel, insert print filament into white
filament feeding pipe till it goes into print head.
7.2.1 Operate on display screen, turn knob and enter main menu, turn knob and make “>” move to
“Prepare”, and then press down, as shown below.
7.2.2 Enter “Prepare” menu, turn knob and make “>” move to “Auto Home”, and then press down,
printer operation system resets automatically, as shown below.
7.2.3 After printer resets, if the distance between nozzle and build bed is of soft contact
【
about as thick
as a piece of A4 paper
】
, then turn off power, freely push extruder with your hands on X/Y direction,
if the distance between the whole build bed and nozzle is same, then you can carry on next step, or
build bed needs to be calibrated.
Notes: Printer has been calibrated before leaving the factory, but transportation may cause declining
of build bed and changing of distance, so build bed needs to be adjusted, check “Maintenance” for
specific adjusting method.
