Electronic Control Card TS004E
Introduction
1
Introduction
1.1
About this user manual
This user manual describes the product Electronic Control Card TS004E (also referred to as "product"
in this document).
This user manual is a part of the product.
■
You may only use the product if you have fully read and understood this user manual.
■
Verify that this user manual is always accessible for any type of work performed on or with the
product.
■
Pass this encoder as well as all other product-related documents on to all owners of the product.
■
If you feel that this user manual contains errors, inconsistencies, ambiguities or other issues, contact
the manufacturer prior to using the product.
There mounting instructions are protected by copyright and may only be used as provided for by the
corresponding copyright legislation. We reserve the right to modifications.
The manufacturer shall not be liable in any form whatsoever for direct or consequential damage
resulting from failure to observe this user manual or from failure to comply with directives, regulations
and standards and any other statutory requirements applicable at the installation site of the product.
1.2
Intended use
This product is a component for installation in control cabinets; it may only be used within the limits
specified in this user manual and in the applicable documents. The applicable documents are also part
of the product.
The machinery must not be put into service until the machinery into which the product has been
incorporated has been determined and declared in conformity with the provisions of Directive 2006/42/
EU and of the EMC Directive 2014/30/EU and with all other applicable directives and regulations.
In addition, perform a risk assessment in view of the planned application, according to an approved risk
assessment method, and implement the appropriate safety measures, based on the results of the risk
assessment. Take into account the consequences of installing or integrating the product into a system
or a plant.
WEISS devices comply with the applicable regulations of VDE. The VDE regulations must also be
observed for modification or disassembly of the device. This manual contains information on EMC-
compliant installation. The manufacturer of the machine or system is responsible for compliance with
all applicable EMC regulations and directives.
1.3
Predictable incorrect application
Any use of the product beyond the explicitly indicated intended use is an impermissible, incorrect
application of the product.
The product must never be used in the following cases, under the following conditions, and for the
following purposes:
■
Operation of the product in potentially explosive atmospheres/hazardous areas
4 / 29
User manual_082018_1.0_en
