WEISS INT203, Руководство пользователя

Страница: 29 / 34

23
the indicated sampling rate does not necessarily reflect the one fed from
the external device. In this case set the sampling rate as indicated by the
Measured Sampling Rate within Device Settings/General .
Sync Source selects the clock to which the INT203 should sync to. For playback
this is usually the INT203 ’s Internal clock generator.
Buffer Size larger buffer sizes increase robustness against dropouts; lower buffer
sizes provide low latency.
Operation Mode determines the stability of the system. Try other modes if
clicks are encountered during playback.
Global Settings/WDM Enables the WDM driver and allows you to modify
the WDM input and output channel routing. In terms of input channel selection,
this is an alternative to the primary input selection switch on the INT203 s
backpanel.
Global Settings/DPC Determines your computer’s performance and recom-
mends an operation mode.
Global Settings/System Various utilities to determine the chipset in your
computer and to get information on the supported chipset. Required for debug-
ging if problems with the Firewire connection are encountered.
Global Settings/Info Information about the driver version.
Device Settings/General The device settings should be pretty self-explana-
tory.
Device Settings/Firmware Loader Allows uploading new firmware to the
INT203 . Not used for normal operation.
Mac OS X
Configure the INT203 via the Audio MIDI Setup ( Applications
→
Utilities )
and the WeissFirewire Control Panel ( Applications ). Note that most settings
controllable from the control panel are available only in Firewire mode.
Global Settings/Bus
Master indicates the sync master on the virtual bus in case multiple devices
(e.g. INT203 s) are connected.
Sampling Rate selects the sampling rate of the device’s internal clock gener-
ator. When clocked/syncing to one of the input interfaces (XLR, RCA)
the indicated sampling rate does not necessarily reflect the one fed from