OPERATING INSTRUCTIONS FOR GAMBIT EQUALIZER EQ1-MK2
OPERATION
Daniel Weiss Engineering Ltd., Florastr. 42, CH-8610 Uster
Page 8 of 26
)
+41 1 940 20 06
2
+41 1 940 22 14
8
http://www.weiss.c
*
Over-samples are defined as
exceeding
the
24bit integer range. A full scale signal
(0dBFS) will not be treated as over. A signal
that triggered an over in a previous pro-
cessor in the audio chain will therefore not
trigger an over in the EQ1 (unless boosted).
Remote Group
Situated adjacent to key C, displays remote con-
trol protocol (“MIDI”, “RS 232” or “RS 422”),
channel (“1” - “16”) and status (on/ off, displayed
with check box).
For remote control set-up see chapter Remote
Control.
Snapshot Display
Bottom line in the status display. Refer to this for
information on current workspace and snapshot.
There are two workspaces (“A” and “B”) for
quick comparison of two equalizer settings. A
workspace can be stored to a snapshot for later
use.
The number of the last recalled snapshot will be
displayed. If you change any value after the recall,
the “ ” will change to “ ” to symbolize that the
workspace is not equal to the displayed snapshot
anymore.
For snapshot handling see chapter Snapshots (p.
12).
Dither Icon
The dither icon is situated right next to key D
(see Graph 2). If dither is off, the icon contains
the number “24“, the word length of the output
signal in bits. Turning dither on will produce ar-
rows above and below the new word length
number (“16“ or “20“). Additionally, if auto-
blacking is enabled, the bottom right corner of
the icon is inverted.
For details on dither refer to chapter Dither (p.
14).
