6
MT8-COM3/RZC004850
5
9
1
6
1
5
6
9
1
5
6
9
5
9
1
6
2.4.5 Dip Switch
z
Touch Screen Calibrate and Reset Password mode: In
this mode when you power on the MT-8000, the screen
will display a “+” sign at the center of the screen. Use a
stylus or finger to push the center of the “+” until it
moves. The “+” moves to upper-left, upper-right, lower-
left and lower-right corners. When all five “+” are done
the “+” will disappear. The Touch Screen parameter will
store at Flash Rom.
z
If losing or forgetting system passwords, users can set
Dip Switch 1 to “ON” position, the rest of Dips remain
on “OFF” position and then reboot MT8000.Under this
situation, MT8000 will jump to Touch Adjust (Touch
screen calibration) mode. After calibration, the pop-up
window appears as the illustration below. Users will be
inquired if restoring the system password to the default
value.
z
When “YES” is chosen, another pop-up dialog appears
as below. Users will be confirmed again if restoring the
system password to the default value and will be asked
to input “YES”. Then click OK. (The default password
is 111111. However, other passwords, including
download and upload password, have to be reset.)
Note: When the reset action is be taken, projects and saved data in the HMI will all be cleared.
SW1
SW2 SW3 SW4 Mode
ON
OFF OFF OFF Touch Screen Calibrate mode
OFF
ON OFF OFF Reserve
OFF
OFF ON
OFF Boot Loader mode
OFF
OFF OFF ON Reserve
OFF
OFF OFF OFF Normal
