weinor BiEasy 15M Go!, Руководство по эксплуатации

Страница: 77 / 88

Ⓒ weinor GmbH & Co. KG EN | 77
1. Engage the UP , the DOWN button and the program-
ming P button (rear of the device) simultaneously (for
3 seconds) on a transmitter that has already been pro-
grammed to the receivers.
The status display lights briefly. The receiver is now in
programming mode.
2. Engage the programming button P on the transmitter to be
programmed until the status display lights briefly. The receiver
is now in programming mode (movements up and down).
3. Immediately (no more than 1 second) after the curtain
starts moving upwards, press the
UP
button. The status
display lights briefly. The blind stops briefly, starts moving
again and then moves downwards.
4. Immediately (no more than 1 second) after the curtain
starts moving downwards, press the DOWN button. The
status display lights briefly. The blind stops.
The transmitter is now programmed.
If more than 10 bidirectional receivers are being programmed
in one channel at the same time, the transmitter channel in
programming mode switches to group mode. Group mode is
indicated by fast flashing with pauses.
Programming in group mode is completed after the buttons
or the joystick have not been engaged for 2 minutes or by
holding down the
STOP button for 6 seconds.
Important:
For venetian blinds, a jogging mode for quickly reaching
receivers which are further away is not possible in a trans-
mitter channel with more than 10 programmed receivers.
BiEasy-15Mgo_weinor_BA_1811EN_0218.indb 77 26.02.2018 13:50:48