weinor BiEasy 15M Go!, Руководство по эксплуатации

Страница: 75 / 88

Ⓒ weinor GmbH & Co. KG EN | 75
4.6 Programming the transmitter
For programming receivers, a maximum of 15 individual
channels are available. After selecting the channel, the
programming process can be started with the
P button.
During an ongoing programming process, it is possible to
switch between empty and already programmed channels
(except when programming in a channel that has more than
10 receivers at the same time).
Requirement :
The bidirectional receiver is installed.
Stand in front of the blind to be programmed while
programming.
1. Where electrical receivers have already been installed,
switch the circuit breaker off and on again after a few
seconds. The receiver will now be in programming mode
for about 5 minutes.
2. Engage the programming button
P
on the rear of the
device briefly (approximately 1 second) until the status
display lights up briefly. The blind moves up and down for
approximately two minutes, showing that the receiver is
in programming mode.
3. Immediately (no more than 1 second) after the curtain
starts moving upwards, press the UP button.
The status display lights briefly.
The blind stops briefly, starts moving again and then
moves downwards.
BiEasy-15Mgo_weinor_BA_1811EN_0218.indb 75 26.02.2018 13:50:48