Weinmann MEDUMAT Standard2, Инструкция по эксплуатации

Страница: 88 / 272

88 EN MEDUMAT Standard
2
WM
6807
1
0
5
/2
021
4 Preparation and operation
Depending on the preset in the operator menu, the device
switches to one of the following modes with the ventilation
parameters preset for the patient group
(see "14.1.10 Factory
settings for emergency modes and ventilation modes",
page 257)
:
• IPPV
• B ASB (only with activated B ASB option)
If the Capnography option is activated, the device shows a
pressure gauge view or a curve view depending on the preset
in the operator menu
(see "6.3.8 Presets patient", page 132) .
Result Ventilation is carried out in RSI mode.
4.8 Monitoring the patient
During ventilation, you must monitor the patient continuously.
You can see the ventilation progress on the pressure gauge, on the
ventilation curves and on the measurements shown on the display
of the device
(see "3.3.2 Ventilation mode (example)", page 28) .
High airway resistances, e.g., due to obstructions of the airways or
during external chest compression, may change the respiratory
minute volume, depending on the ventilation mode.
In the event that the compliance of the lungs is reduced, during
volume-controlled ventilation the device reacts by increasing the
ventilation pressure to the set pressure limit whilst the ventilation
volume remains constant. Then the applied volume drops.
All the measurements shown for flow, tidal volume and minute
volume relate to standard body temperature and ambient
pressure (BTPS (Body Temperature and Pressure, saturated):
Volume at current ambient pressure and 37 °C, with 100 %
saturated gas).