Weinmann Emergency MODUL CapnoVol, Инструкции по обслуживанию и ремонту

Страница: 27 / 44

Repair information and repair instructions 27
8. Hold bottom part of the housing
24
and the
circuit boards in one hand, turn bottom part of
the housing
24
over and screw in the four
hexagon screws
50
.
Caution!
When fitting the power supply connection, the
Capno connection adapter and the connection
for the BiCheck flow sensor, ensure that the
connections are correctly positioned in the
corresponding ducts in the housing (groove
and spring), otherwise the connections or the
bottom part of the housing may be damaged.
9. Push power supply connection
9
into the
corresponding bore of bottom of the housing
24
and screw it up with a hexagon nut
35
.
10. Push Capno connection adapter
43
into the
corresponding bore of bottom part of the
housing
24
and screw it up with a nut
35
as
described in Section “7.4 Replace the Capno
connecting adapter” on page 24.
11. Push BiCheck flow sensor connection
8
into the
corresponding bore in the bottom of the
housing and screw it up with hexagon nut
35
.
12. Put battery
30
in the bracket in the bottom of
the housing and connect the connector of
battery
30
to connection
X1
on the circuit
board.
13. Close the device (see “7.3 Close the device”
on page 23).
14. Test the device (see “4. Test the device” on
page 8).
Note
Return the faulty circuit boards to
WEINMANN.
43
30
9
8
24
35
X1